Welcome To Damien's Build Blog

Damien posted by Alicia on 08/14/2006
This is the list of things I did on Damien.
1: I drill the hole for the bearings to hold the shaft for the weapon.
2: I instale the tube that would hold the drive motor. It goes on the bottum of the body on the back.
3: The back gets suports to hold the tube for the drive.
4: Now working on making the wheel guards. The motors I use need them. It needs support on both side of the wheels.

I drew a picture of how my bot is going to look.



0 comments send to friend

Damien Build Report #1 posted by Alicia on 07/22/2006
Here is a couple of pictures of my bot that I started building. This bot is made up of channel, angle and plate. First I cut the channel to size. I bolt it togeather. I cut some channel to put in the front. Angle went in the inside. All of this is made of AL. The back.........
full story
0 comments send to friend

Rebuilding Damien posted by Alicia on 07/09/2006
I built a 30lber name Damien. It is a bar spinner like the 30lber name Bear Tracks. The bar was in the front, between the frame. The motor that power the weapon is a EV. For the drive, I used 18v dewalts. When I got the bot done, it was overweight. Tryed to lighten it up, but it was still overweight. I took it to Robogames and fought it without the weapon. Damien is going to be rebuild, so it can use the weapon. The new Damien would be kind of like TO. The body is on top and and the blade is on the bottum. The drive is going to be on the back in a 3" tube. Here is a picture of the first Damien.


0 comments send to friend

archive

 
c o m b a t - r o b o t i c s